It depends on battery charge, electrical load and various temperatures. The system doesn't ever turn itself off using the switch. If there is a fault preventing the system working, a warning will show on the dash. If it's just not stopping because the parameters haven't been met, that isn't actually a fault. This is on a 57 plate Mondeo Titanium X. The normal key reprogramming trick of turning the key in the ignition so many times in 6 seconds wont work, as there's no ignition. The failsafe involves inserting the fob into where the ignition would be. Any help would be appreciated. Hi I have had my mondeo over 12 months now and never had the parking sensors working the light on the dash flashes 6 times no bleep then nothing had my mechanic plug his code reader in and he said it was the ns middle sensor..when inspected the wire was worn so I bought a complete wiring loom with sensors tested working to replace the old one David2206. A Quick fix if your "Bonnet Open" warning on dash comes up and possibly electric windows, washer pump, air blowers and mirrors stop working. Take bonnet sensor socket off the bottom/ underneath side of the latch assembly carefully, it may have a squeeze connector on the side of it. Ford Model: Mondeo Titanium 1.5 TDCi. Ford Year: 2017. UK/Ireland Location: Leicestershire. Posted March 2, 2020. The wires from the start button go to the BCM. It's the BCM that sends the signal to the starter. Try the following: 1) Get in the car, press the start button, then immediately try and start the car. Hi, I have Mondeo mk4 2011 and the windshield wipers does not work properly. When turned on, they will run for 9 strokes before stopping somewhere om the windshield. This happens 3 times before they stop working alltogether. Then I must either stop the car and turn the ignition of and restart the engine, then they will work in the same fashion WGcpd. Hi everyone. I am having a bit of a nightmare with my dash cam installation in my Ford Mondeo Titanium 2009. I am trying to find a fuse within the central fuse box that powers on with the ignition. When I connect the nextbase hard wire kit fuse adaptor to piggyback on a fuse, the dash cam is alwa Part 1 described the operation of the keyless start system. The keyless entry option builds on this by adding a few components. The same KVM is used for both systems. For the keyless entry option there is a low frequency antenna built into the drivers and passenger's front door handles. Also there is one behind the rear bumper. 2009 Ford Mondeo 1.6 No dashboard indication and central No dashboard indication and central locking not working 2009 Ford Mondeo 1.6. Problem added: Nov 11, 2020 It depends on battery charge, electrical load and various temperatures. The system doesn't ever turn itself off using the switch. If there is a fault preventing the system working, a warning will show on the dash. If it's just not stopping because the parameters haven't been met, that isn't actually a fault. Ford Model: Mondeo Titanium 1.5 TDCi. Ford Year: 2017. UK/Ireland Location: Leicestershire. Posted March 2, 2020. The wires from the start button go to the BCM. It's the BCM that sends the signal to the starter. Try the following: 1) Get in the car, press the start button, then immediately try and start the car. Mondeo econetic start/stop has Stopped start/stopping. Start/stop has gone from intermittently not working, to not working period. I believe it is just a wiring connection but Haynes manual gives not wiring connections for this system , can anyone advise of locations of switches and capacitor etc. I have power to the dashboard switch or at

ford mondeo mk4 dashboard not working